|تعداد مشاهده مقاله||8,864,055|
|تعداد دریافت فایل اصل مقاله||5,836,986|
Thermo-Hydraulic Investigation of Nanofluid as a Coolant in VVER-440 Fuel Rod Bundle
|Challenges in Nano and Micro Scale Science and Technology|
|مقاله 2، دوره 3، شماره 2، مهر 2015، صفحه 77-88 اصل مقاله (2.09 M)|
|نوع مقاله: Original Research Paper|
|شناسه دیجیتال (DOI): 10.7508/tpnms.2015.02.002|
|S. Jalili Palandi1، 2؛ A. Rahimi-Sbo1؛ M. Rahimi-Esbo* 1، 2|
|1Department of Mathematics, Buinzahra Branch, Islamic Azad University, Buinzahra, I.R. Iran|
|2School of Mechanical Engineering, Babol University of Technology, Babol, I.R. Iran|
|The main purpose of this study is to perform numerical simulation of nanofluids as the coolant in VVER-440 fuel rod bundle. The fuel rod bundle contains 60 fuel rods with length of 960 mm and 4 spacer grids. In VVER-440 fuel rod bundle the coolant fluid (water) is in high pressure and temperature condition. In the present Thermo-hydraulic simulation, water-AL2O3 nanofluids containing various volume fractions of AL2O3 nanoparticles are investigated. Calculations performed for Reynolds number of 125000 to 203000, nanoparticles fraction of 0 to 0.05 and nanoparticles diameter of 20 to 100 nm. In this literature, the effects of diameter and volume fraction of nanoparticles on thermo-hydraulic parameters are studied. To perform correct calculation, different grid qualities of fuel rod bundle are studied and results are compared with reference results. Empirical studies show that as the temperature rises, the effect of nanoparticles on enhancing thermal conductivity intensifies. So it can be said that as the VVER-440 fuel rod bundle works in high temperature condition, using the nanofluids in this rod bundle can be effective. Results of our numerical study showed that by using nanofluids as coolant fluid the heat transfer coefficient increases significantly and heat transfer enhancement raises with increase in volume fraction of nanoparticle.|
|Heat transfer coefficient؛ Nanofluid؛ Particle diameter؛ Rod bundle؛ Volume fraction|
 M. E. Conner, E. Baglietto, A. M. Elmahdi, CFD methodology and validation for single-phase flow in PWR fuel assemblies, Nuclear Engineering and Design 240 (2010) 2088–2095.
 S. Tóth, A. Aszódi, Calculations of coolant flow in a VVER-440 fuel bundle with the code ANSYS CFX 10.0, Proceedings of the Workshop on Modeling and Measurements of Two-Phase Flows and Heat Transfer in Nuclear Fuel Assemblies, Stockholm, Sweden (2006).
 M. R. Abdi, M. Asgari, Kh. Rezaee Ebrahim Saraee, M. Talebi, Numerical Simulation of Split Vane in a 60 Fuel Rod Bundle of VVER-440 Reactor and Survey the Effect of Large Length Split Vane (LLSV) and Half-Length Split Vane (HLSV) on Heat Transfer Distribution. World Applied Sciences Journal 18 (7) (2012) 909-917.
 B. C. Rahimi, G. Jahanfarnia, Thermal-hydraulic core analysis of the VVER-1000 reactor using a porous media approach, Journal of Fluids and Structures 51 (2014) 85–96.
 M. Jabbari, k. Hadad, G. R. Ansarifar, Z. Tabadar, Power calculation of VVER-1000 reactor using a thermal method, appliedto primary–secondary circuits, Annals of Nuclear Energy 18 (77) (2015) 129-132.
 S.U.S. Choi, Enhancing thermal conductivity of fluid with nanoparticles, ASME FED 231/MD. 66 (1995) 99–103.
 P. Keblinski, S. R. Phillpot, S.U.S. Choi, J. A. Eastman, Mechanisms of heat flow in suspensions of nano-sized particles(nanofluid), Int. J. of Heat and Mass Transfer 45 (2002) 855–863.
 J. A. Eastman, S. R. Phillpot, S.U.S. Choi, P. Keblinski, Thermal transport in nanofluids, Annual Review of Materials Research 34 (2004) 219–246.
 O. Ghaﬀari, A. Behzadmehr, H. Ajam, Turbulent mixed convection of a nanofluid in a horizontal curved tube using a two-phase approach, International Communications in Heat and Mass Transfer 37 (10) (2010) 1551–1558.
 A. Behzadmehr, M. Saﬀar Avval, N. Galanis, Prediction of turbulent forced convection of a nanofluid in a tube with uniform heat flux using a two phase approach, Int. J. of Heat and Fluid Flow 28 (2) (2007) 211–219.
 C. Abdellahoum, A. Mataoui, H. Oztop, Turbulent forced convection of nanofluid over a heated shallow cavity in a duct, Annals of Nuclear Energy 277 (2015) 126-134.
 A. Moghadassi, E. Ghomi, F. Parvizian, A numerical study of water based Al2O3 and Al2O3–Cu hybrid nanofluid effect on forced convective heat transfer, International Journal of Thermal Sciences 92 (2015) 50–57.
 J. Buongiorno, B. Truong, Preliminary study of water- based nanofluid coolants for PWRs, Transactions of the American Nuclear Society 92 (2005) 383–384.
 K. Hadad, A. Hajizadeh, K. Jafarpour, B.D. Ganapol, Neutronic study of nanofluids application to VVER-1000, Annals of Nuclear Energy 37(11) (2010) 1447–1455.
 E. Zariﬁ, G. Jahanfarnia, F. Veysi, Thermal–hydraulic modeling of nanofluids as the coolant in VVER-1000 reactor core by the porous media approach, Annals of Nuclear Energy 51 (2013) 203–212.
 K. Hadad, A. Rahimian, M. R. Nematollahi, Numerical study of single and two-phase models of water/Al2O3 nanofluid turbulent forced convection flow in VVER-1000 nuclear reactor, Annals of Nuclear Energy 60 (2013) 287-294.
 O. Ltd, User guide, http://www.openfoam.com /docts/user/; (2011).
 S. P. Janga, S.U.S. Choi, (Role of Brownian motion in the enhanced thermal conductivity of nanofluids, Applied Physics Letters 84 (2004) 4316-4318.
 C. H. Chon, K. D. Kihm, S. P. Lee, S.U.S. Choi, Empirical correlation finding the role of temperature and particle size for nanofluid (Al2O3) thermal conductivity enhancement, Applied Physics Letters 87 (2005) 153107–153110.
 H. A. Mintsa, G. Roy, C. T. Nguyen, D. Doucet, New Temperature Dependent Thermal Conductivity Data for Water-Based Nanofluids, Int. J. of Therm. Sci 48 (2009) 363–371.
 N. Masoumi, N. Sohrabi, A. A. Behzadmehr, New Model for Calculating the Effective Viscosity of Nanofluids, Journal of Physics D: Applied Physics 42 (2009) 55501–55506.
 B. C. Pak, Y. I. Cho, Hydrodynamic and HeatTransfer Study of Dispersed Fluids with Submicron Metallic Oxide Particles, Experimental Heat Transfer 11 (1998) 151–170.
تعداد مشاهده مقاله: 2,682
تعداد دریافت فایل اصل مقاله: 2,703