تعداد نشریات | 27 |
تعداد شمارهها | 566 |
تعداد مقالات | 5,822 |
تعداد مشاهده مقاله | 8,158,635 |
تعداد دریافت فایل اصل مقاله | 5,458,172 |
A New Boost DC-DC Converter Based on a Coupled Inductor and Voltage Multiplier Cells | ||
International Journal of Industrial Electronics Control and Optimization | ||
مقاله 1، دوره 2، شماره 4، دی 2019، صفحه 265-278 اصل مقاله (1.43 MB) | ||
نوع مقاله: Research Articles | ||
شناسه دیجیتال (DOI): 10.22111/ieco.2019.28215.1127 | ||
نویسندگان | ||
Mahmoodreza Eskandarpour Azizkandi![]() ![]() | ||
1Department of Electrical and Computer Engineering, University of Mohaghegh Ardabili, Ardabil, Iran | ||
2Department of Electrical and Computer Engineering, Faculty of Engineering, University of Mohaghegh Ardabili, Ardabil, Iran | ||
چکیده | ||
A new non-isolated, coupled-inductor, single-switch boost DC-DC converter for photovoltaic (PV) power application is introduced in this paper. A coupled inductor and voltage multiplier cells is used in the presented converter to obtain a high voltage conversion ratio. Also, a passive clamp circuit is applied in the converter structure to reduce voltage stress of the power switch. This leads to using a power switch with lower on-state resistance in the converter which decreases the conduction loss. In addition, zero current switching (ZCS) condition for the power switch is achieved due to the use of the clamp circuit. Several advantages such as low operating duty cycle, high voltage conversion ratio, reduced voltage stress of semiconductors, low turn ratio for the coupled inductor, leakage inductance reverse recovery and high efficiency operation make the presented converter suitable for renewable energy applications. The steady state operation of the suggested structure in continuous conduction mode (CCM) and discontinuous conduction mode (DCM) is expressed and analyzed. Then, the presented topology is compared with several similar high gain topologies to prove its advantages. Finally, experimental measurement results of a laboratory prototype of the proposed DC-DC converter with about 213W output power and 435V output voltage at 50 kHz switching frequency are presented to corroborate its feasibility and performance. | ||
کلیدواژهها | ||
DC-DC converter؛ Coupled inductor؛ Reduced voltage stress؛ Voltage multiplier cells؛ Photovoltaic application | ||
مراجع | ||
[1] S.H. Hosseini, M. Sarhangzadeh, M.B.B Sharifian, and F. Sedaghati, “Using PV in distribution network to supply local loads and power quality enhancement,” International Conference on Electrical and Electronics Engineering (ELECO 2009), pp. I-249 - I-253, Nov 2009. [2] J. Farzaneh, R. Keypouror, and A. Karsaz, “A novel fast maximum power point tracking for a PV system using hybrid PSO-ANFIS algorithm under partial shading conditions, ” International Journal of Industrial Electronics, Control and Optimization (IECO), Vol. 2, No. 1, pp. 47-58, winter 2019. [3] F. Sedaghati, Sh. Mohammad Salehian, H. Shayeghi, and E. Shokati Asl, “A configuration of double input Z-source DC-DC converter for standalone PV/battery system application,” Journal of Energy Management and Technology (JEMT), Vol. 2, No. 3, pp. 60-69, Summer 2018. [4] M. Forouzesh, Y.P. Siwakoti, S.A. Gorji, F. Blaabjerg, and B. Lehman, “Step-Up DC–DC converters: a comprehensive review of voltage-boosting techniques, topologies, and applications,” IEEE Transactions on Power Electronics, Vol. 32, No. 12, Dec 2017. [5] M. Forouzesh, Y. Shen, K. Yari, Y.P. Siwakoti, and F. Blaabjerg, “High-efficiency high step-up DC–DC converter with dual coupled inductors for grid-connected photovoltaic systems,” IEEE Transactions on Power Electronics, Vol. 33, No. 7, July 2018. [6] S.H. Hosseini, F. Sedaghati, M. Sabahi, and GB. Gharepetian, “Zero voltage switching analysis of modular isolated bidirectional DC-DC converter,” 27th Canadian Conference on Electrical and Computer Engineering (CCECE), IEEE, Canada, 2014. [7] F. Sedaghati, S.H. Hosseini, M. Sabahi, and G.B. Gharepetian, “Analysis and implementation of a modular isolated zero-voltage switching bidirectional dc–dc converter,” IET Power Electronics, Vol. 7, No. 8, pp. 2035–2049, 2014.[8] H. Ardi, R.R. Ahrabi, and S. Najafi Ravadanegh, “Non-isolated bidirectional DC–DC converter analysis and implementation,” IET Power Electronics, Vol. 7, No. 12, pp. 1755-4535, 2014. [9] M.R. Banaei, and H. Ajdar Faeghi Bonab, “A novel structure for single switch non-isolated transformerless buck-boost DC-DC converter,” IEEE Transactions on Industrial Electronics, Vol. 64, No. 1, pp.198-205, 2017. [10] K. Varesi, S.H Hosseini, M. Sabahi, E. Babaei, S. Saeidabadi, and N. Vosoughi, “Design and analysis of a developed multi-port high step-up DC-DC converter with reduced device count and normalized peak inverse voltage on the switches/diodes,” IEEE Transactions on Industrial Electronics, Early Access, 2018. [11] S.M. Chen, T.J. Liang, L.S. Yang, and J.F. Chen, “A boost converter with capacitor multiplier and coupled inductor for AC module applications,” IEEE Transactions on Industrial Electronics, Vol. 60, No. 4, pp. 1503-1511, Apr. 2013. [12] Y.P. Hsieh, J.F. Chen, T.J. Liang, and L.S. Yang, “Novel high step-up DC–DC converter for distributed generation system,” IEEE Transactions on Industrial Electronics, Vol. 60, No. 4, pp. 1473–1482, Apr. 2013. [13] E. Babaei, H. Mashinchi Maheri, M. Sabahi, and S.H. Hosseini, “Extendable nonisolated high gain DC–DC converter based on active–passive inductor cells,” IEEE Transactions on Industrial Electronics, Vol. 65, No. 12, pp. 9478 - 9487, 2018. [14] R. Moradpour, H. Ardi, and A. Tavakoli, “Design and implementation of a new SEPIC-based high step-up DC/DC converter for renewable energy applications,” IEEE Transactions on Industrial Electronics, Vol. 65, No. 2, pp. 1290 – 1297, 2018. [15] A. Farakhor, M. Abapour, and M. Sabahi, “Study on the derivation of the continuous input current high-voltage gain DC/DC converters,” IET Power Electron, Vol. 11, No. 10, pp. 1652 - 1660, 2018. [16] S. Pourjafar, F. Sedaghati, H. Shayeghi, and M. Maalandish, “A new high step-up DC-DC converter with coupled inductor and voltage lift circuit combination suitable for renewable applications,” IET Power Electronics, Vol. 12, No. 1, pp. 92 - 101, 2019. [17] A. Farakhor, H. Ardi, and M. Abapour, “Analysis and design procedure of a novel high voltage gain DC/DC boost converter,” 8th Power Electronics, Drive Systems & Technologies Conference (PEDSTC), IEEE, Mashhad, Iran, 2017. [18] H. Ardi, A. Ajami, and M. Sabahi, “A novel high step-up DC-DC converter with continuous input current integrating coupled inductor for renewable energy application,” IEEE Transactions on Industrial Electronics, Vol. 65, No. 2, pp. 1306 – 1315, 2018. [19] J. Javidan, “Design of a ZVS PWM DC–DC converter for high gain applications,” International Journal of Circuit Theory and Applications, Vol. 44, No. 5, pp. 977–995, 2016. [20] A. Ajami, H. Ardi, and A. Farakhor, “A novel high step-up DC-DC converter based on integrating coupled inductor and switched-capacitor techniques for renewable energy applications,” IEEE Transactions on Power Electronics, Vol. 30, No. 8, pp. 4255-4263, Aug 2015. [21] Y.T. Chen, Z.X. Lu, R.H. Liang, and C.W. Hung, “Analysis and implementation of a novel high step-up DC–DC converter with low switch voltage stress andreduced diode voltage stress,” IET Power Electron, Vol. 9, No. 9, pp. 2003-2012, Jul 2016. [22] M. Eskandarpour Azizkandi, F. Sedaghati, and H. Shayeghi, “Design of a new step-up DC-DC converter with high voltage gain for PV power application,” 33rd International Power System Conference, Tehran, Iran, October 2018. Available on: http://www.psc-ir.com/cd/2018/papers/1838.pdf [23] Y.P. Hsieh, J.F. Chen, T.J.P. Liang, and L.S. Yang, “Novel high step-up DC–DC converter with coupled-inductor and switched-capacitor techniques for a sustainable energy system,” IEEE Transactions on Power Electronics, Vol. 26, No. 12, pp. 3481-3490, Dec 2011. [24] Y.P. Hsieh, J.F. Chen, T.J. Liang, and L.S. Yang, “Novel high step-up DC–DC converter with coupled-inductor and switched-capacitor techniques,” IEEE Transactions on Industrial Electronics, Vol. 59, No. 2, pp. 998–1007, Feb 2012. [25] B. Honarjoo, S.M. Madani, M. Niroomand, and E. Adib, “Analysis and implementation of a new single switch, high voltage gain DC-DC converter with a wide CCM operation range and reduced components voltage stress,” Journal of Power Electronics, Vol. 18, No. 1, pp. 11-22, Jan 2018. [26] M. Khalilzadeh, and K.Abbaszadeh, “Non-isolated high step-up DC–DC converter based on coupled inductor with reduced voltage stress,” IET Power Electronics, Vol. 8, No. 11, pp. 1755-4535, 2015. [27] M. Mohammadi, M. Taheri, J. MiliMonfared, B. Abbasi, and M.R. Mohammadian Behbahani, “High step-up DC– DC converter with ripple free input current and soft switching,” IET Power Electronics, Vol. 7, No. 12, pp. 3023 - 3032, 2014. [28] H. Shojaeian, S. Hasanzadeh, and M. Heydari, “High Efficient and High Step-Up Dual Switches Converter Based on Three Coupled Inductors,” International Journal of Industrial Electronics, Control and Optimization (IECO), Vol. 1, No. 2, pp. 143-152, summer 2018. [29] M. Maalandish, S.H. Hosseini, S. Ghasemzadeh, E. Babaei, R.Sh. Alishah, and T. Jalilzadeh, “Six-phase interleaved boost dc/dc converter with high-voltage gain and reduced voltage stress,” IET Power Electronics, Vol. 10, No. 14, pp. 1904-1914, 2017. [30] T. Nouri, N. Vosoughi, S.H. Hosseini, and M. Sabahi, “A novel interleaved non-isolated ultrahigh-step-up DC–DC converter with ZVS performance,” IEEE Transactions on Industrial Electronics, Vol. 64, No. 5, pp. 3650-3661, 2017. | ||
آمار تعداد مشاهده مقاله: 1,101 تعداد دریافت فایل اصل مقاله: 809 |